MTP Instruments Inc. MTP3100 Manuale Utente
14
each grid will stand for a value of 20kWh (as per Fig. 43).
If the highest histogram is higher than 100kWh, the full scale of the histogram is displayed as 1000kWh. That means each grid
will stand for a value of 200kWh (as per Fig.44).
The grid appears when its real value is more than 1/3 of its value.
If the highest histogram is higher than 100kWh, the full scale of the histogram is displayed as 1000kWh. That means each grid
will stand for a value of 200kWh (as per Fig.44).
The grid appears when its real value is more than 1/3 of its value.
10. Transmitter Signal Frequency Setting
Use a slim stick to push the setting hole on the transmitter and hold there for 3 seconds, the LED light will change its color
among red light, yellow light, and green light.
Choose red light for the frequency of 10s, yellow light for 15s and green light for 20s.
After setting, the LED light will always flash in the selected color.
among red light, yellow light, and green light.
Choose red light for the frequency of 10s, yellow light for 15s and green light for 20s.
After setting, the LED light will always flash in the selected color.
11. FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to
(2) This device must accept any interference received, including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
12.
IC
STATEMENT
- English: "
1. This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the
(2) this device must accept any interference, including interference that may cause undesired operation of the
device."
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
- French:"
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement."