Arcadyan Technology Corporation WA8001AAC Manuale Utente

 

™

Installa

tIon Gu

Ide

ReGulatoRY InFoRMatIon

FEDERAL COMMUNICATIONS COMMISSION NOTIFICATION

This device complies with Part 15 of the FCC Rules. Operation is subject to the 

following two conditions: 

(1) this device may not cause harmful interference, and 

(2)  this device must accept any interference received, including

     interference that may cause undesired operation.  

This equipment has been tested and found to comply with the limits for a Class B 

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to 

provide reasonable protection against harmful interference in a residential installation. 

This equipment generates, uses and can radiate radio frequency energy and, if not 

installed and used in accordance with the instructions, may cause harmful interference 

to radio communications. However, there is no guarantee that interference will not 

occur in a particular installation. If this equipment does cause harmful interference to 

radio or television reception, which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the interference by one or more of the 

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

•  Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected.

•  Consult the dealer or an experienced radio/TV technician for help.

Do not make changes or modifications to this equipment. This could void the user’s 

authority to operate the equipment.

Product must be installed at least 20 cm (~8 inches) from typical person locations per FCC 

RF exposure regulations.

Operation of Wi-Fi on channels 5150-5250 MHz is restricted to indoor use only.

If none of the remedies stops the radio interference, you should contact a licensed radio/

television technician, your satellite dealer, or call the Customer Service Center at 1-800-333-

DISH (3474), for assistance.

Copyright © 20

14. Ec

hoStar 

Tec

hnologies L.L.C., Englew

ood, 

Colorado 8011

2. All rights reser

ved. DISH is a registered trademark 

of DISH Netw

ork L.L.C. Other products, brands, and companies 

mentioned are the Trademarks of their respectiv

e owner(s). 

This 

product is designed in the United States and manuf

actured in India. 

 

WelCoMe

Thank you for buying the Wireless Joey Access Point

™.  The Wireless 

Joey Access Point transmits the WiFi video signals from the Hopper to the 
Wireless (WiFi) Joey.  Please follow these instructions to connect your new 
Wireless Joey Access Point. You can also visit http://mydish.com for additional 
information on home networking.

PaCKaGe Contents: 

Wireless Joey 

access Point

Power
WiFi signal
ethernet
WPs

Power supply 

Installation Guide

For all y

our customer needs, go to

hat or call the 

Customer Service Center at

ethernet Cable 

(10 foot cable)

FCC Caution: Any changes or modifications not expressly approved by the party  

responsible for compliance could void the user’s authority to operate this equipment. 

For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of 
other channels is not possible.

This device and it's antennas(s) must not be co-located or operating in conjunction with any other 
antenna or transmitter except in accordance with FCC multi-transmitter  

product procedures. 

Devices will not permit operations on channels 120-132 for 11a and 11n/a which overlap the 5600 - 
5650 MHz band.