Arcadyan Technology Corporation WE410443 Manuale Utente
1041400-0001 Revision B
April 6, 2017
1
2
Setting Up Your Hughes Wi-Fi Booster With Your HT2000W Modem
Check the box contents
Before you begin, make sure the box has the contents shown in
Figure 1
.
Figure 1: Box contents
Configure the Booster
For the initial setup, you must be near the HT2000W. To configure the Hughes
Wi-Fi Booster:
Wi-Fi Booster:
1. Plug the Booster into a power outlet using the provided power supply.
Push the Power button (
) on the back of the device to power it on.
2. Lay the Booster horizontally, as shown in
Figure 2
, so you can clearly see
the LED on the bottom of it. Wait for the LED to turn red. This may take 1
minute. The LED will turn other colors before turning red.
minute. The LED will turn other colors before turning red.
Figure 2: Red LED – Booster is ready for configuration
3. Connect the Booster to the HT2000W with the provided LAN cable.
Connect the cable from the yellow LAN port on the device to any LAN port
on the HT2000W. See
on the HT2000W. See
Figure 3
.
Figure 3: Connect the Booster to the HT2000W
Power supply
Hughes Wi-Fi Booster
LAN cable
150200199500J R01 AMD