Honeywell International Inc. 51306799 Manuale Utente
Installation and Technical Manual for the
Limitless™ Multi-Protocol Receiver,
WMPR Series
Sensing and Productivity Solutions
Issue 1
32309669
m WARNING
PERSONAL INJURY
DO NOT USE these products as safety or emergency stop
devices or in any other application where failure of the product
could result in personal injury.
Failure to comply with these instructions could result in
death or serious injury.
devices or in any other application where failure of the product
could result in personal injury.
Failure to comply with these instructions could result in
death or serious injury.
m WARNING
Honeywell does not recommend using devices for critical
control applications where there is, or may be, a single point
of failure or where single points of failure may result in an
unsafe condition. It is up to the end-user to weigh the risks
and benefits to determine if the products are appropriate for
the application based on security, safety and performance.
Additionally, it is up to the end-user to ensure that the control
strategy results in a safe operating condition if any crucial
segment of the control solution fails. Honeywell customers
assume full responsibility for learning and meeting the required
Declaration of Conformity, Regulations, Guidelines, etc. for
each country in their distribution market.
Failure to comply with these instructions could result in
death or serious injury.
control applications where there is, or may be, a single point
of failure or where single points of failure may result in an
unsafe condition. It is up to the end-user to weigh the risks
and benefits to determine if the products are appropriate for
the application based on security, safety and performance.
Additionally, it is up to the end-user to ensure that the control
strategy results in a safe operating condition if any crucial
segment of the control solution fails. Honeywell customers
assume full responsibility for learning and meeting the required
Declaration of Conformity, Regulations, Guidelines, etc. for
each country in their distribution market.
Failure to comply with these instructions could result in
death or serious injury.
m WARNING
RF EXPOSURE
To satisfy FCC RF exposure requirements for mobile
transmitting devices, a separation distance of 20 cm or more
should be maintained between the antenna of this device
and persons during device operation To ensure compliance,
operation at closer than this distance is not recommended. The
antenna used for this transmission must not be co-located in
conjunction with any other antenna or transmitter.
Failure to comply with these instructions could result in
death or serious injury.
transmitting devices, a separation distance of 20 cm or more
should be maintained between the antenna of this device
and persons during device operation To ensure compliance,
operation at closer than this distance is not recommended. The
antenna used for this transmission must not be co-located in
conjunction with any other antenna or transmitter.
Failure to comply with these instructions could result in
death or serious injury.
m WARNING
The WMPR must be installed in accordance with the
requirements specified in this document in order to comply
with the specific Country Communication Agency requirements
(i.e., FCC, IC, ETSI, ACMA, etc.). See Section 3
requirements specified in this document in order to comply
with the specific Country Communication Agency requirements
(i.e., FCC, IC, ETSI, ACMA, etc.). See Section 3
as this requires
choosing the correct Country Use Code and thus allowable
antenna and/or cable usage.
antenna and/or cable usage.
, CAUTION
Power to the WMPR should not be applied during installation of
an antenna as damage could occur to the WMPR electronics.
an antenna as damage could occur to the WMPR electronics.
m WARNING
• The cable length of the customer-supplied dc power
source to the WMPR supply terminals cannot exceed three
(3) meters.
(3) meters.
• The WMPR must be used indoors.
• The WMPR must be used inside a cabinet and can only be
• The WMPR must be used inside a cabinet and can only be
accessed during set-up or maintenance.