Controlled Entry Distributors Inc. BEST915ALP4K Manuale Utente

3/4

6-1621775             rev00              12/06/2017

Each transmitter is manufactured and sold with a different factory-set serial 
number.

The transmitter must be programmed into your system memory.
Your own installer or reseller will provide you the necessary instructions for 
your system.

A- Firmly depress the button until the red LED illuminates.
B- After the LED has illuminated, release the button.
If the device you are attempting to activate does not respond, repeat steps A 
and B or consult section 6 ( Troubleshooting ) of this manual.

To access the battery, remove the front plastic cover with a screwdriver, see 
Fig. 2.
Slide out the old battery and replace them with the new ones [23A] respecting 
the polarity.
NOTE: Please dispose of the batteries properly according to local laws and regulations.
Test proper battery installation by verifying that the red LED illuminates when the 
button is pushed.

The system does not receiver the 

transmitter signal.

The transmitter LED will not light

Replace the transmitter

batteries

The system does not receiver the 

transmitter signal.

The transmitter LED is ON

Check to verify the transmitter is 

programmed into your sistem

The operating range is reduced

Replace the transmitter

batteries