EnOcean GmbH PTM200C Manuale Utente

 

 

This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. If 

this device is operated in compliance with the following requirements it can be operated 
without notification and free of charge in the area of the United States of America 

. Operation is subject to the following two conditions: 

(1) 

this device may not cause harmful interference, and  

(2) 

this device must accept any interference received, including interference that 

may cause undesired operation. 

 

This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry 

Canada. Operation is subject to the following two conditions. (1) this device may not

cause harmful interference, and (2) this device must accept any interference 

received, including interference that may cause undesired operation. 

 

  

 

 

FCC ID: SZV-PTM200C     

 

IC: 5713A-PTM200C 

 

Trade Name: PTM200C 

Model No: PTM200C 

 
 
 
 
 
 
 
Warning:

 Changes or modifications made to this equipment not expressly approved 

 

This equipment has been tested and found to comply with the limits for a Class B digital 

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable 

protection against harmful interference in a residential installation.  
This equipment generates, uses and can radiate radio frequency energy and, if not installed 

and used in accordance with the instructions, may cause harmful interference to radio 

communications.   
However, there is no guarantee that interference will not occur in a particular installation. If 

this equipment does cause harmful interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures: 

•  Reorient or relocate the receiving antenna. 
•  Increase the separation between the equipment and receiver. 
•  Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected. 

•  Consult the dealer or an experienced radio/TV technician for help. 

Due to FCC 15.231 operational and timing requirements the PTM 200C switch device must 

 (pushed or released as one operation 

each): 

•  Total duration of transmissions must not exceed more than two seconds per hour 
•  PTM 200 packet length is 0.7 ms, max. 5 redundant packets, tolerance of 5% in packet 

length, 50% on average packet Ton/Toff ratio 

 

 
©EnOcean GmbH, W. Heller 

 

Page 17 of 19 

 

 PTM 200C User Manual V1.01