Revolabs 01EXECMICWR Manuale Utente

 

If the network settings are configured incorrectly it can cause an Executive 
Elite system to become disconnected from the network, making access to the 
Web UI over the LAN impossible.  However, the Web UI can still be accessed 
from the USB port on the front panel of the Elite.  Using a micro USB cable 
connect the computer you wish to use with the front USB connector of the 
Executive Elite DSP base.  Driver software might need to be installed on your 
computer on first connection.  Once the driver is installed and available, a 
popup on the Front Panel LCD gives the static IP Address for the USB web 
connection.  Open a web browser and enter the IP Address, then log into the 
Web UI.  Now you may correct any network settings so that the Executive Elite 
base DSP can register with your IP network. 
 
If installing the driver software fails, the IP Address popup does not appear, or 
the USB IP Address Web UI doesn’t load, then the USB connection may be 
faulty.  Try adjusting the wire or try again with a new cable. 

This indicates that the Elite Base DSP Unit and Antenna are not 
communicating.  During a firmware update, after the base upgraded its 
firmware, this state might persist for up to 10 minutes, while antenna firmware 
is being updated. 
 
If no update occurred recently, ensure that the antenna cable is plugged into 
the back of the Elite Base Unit and into the Remote Antenna. 
 
If the cable is connected correctly, restart the Remote Antenna from the 
Administration page of the local Web UI. 
 
If the Antenna hasn’t relinked 2 minutes after the restart command was issues, 
restart the base. 
 

If you are experiencing technical problems or if you have questions about the 
operation, configuration or troubleshooting of any Revolabs product, please 
email support@revolabs.com or call 1-800-326-1088.