Revolabs 01EXECMICWR Manuale Utente

 

Connect the Remote Antenna Receiver with the Antenna output of the Base 
DSP Unit using a CAT 5e or Cat 6 cable.   
NOTE: 

This needs to be a, point to point connection between the two 
units.  This is a time crucial connection.  Routing this connection 
through a switch will fail. 

The Antenna output of the Base DSP unit provides Power over Ethernet which 
is required to power the Remote Antenna.   
 

 

 
Before connecting the network cable, ferrite beads need to be installed on 
either end of the cable to minimize electro-magnetic interference.  One ferrite 
bead should be attached ¼-⅜ of an inch (7 – 10 millimeters) from the end of 
the cable that will connect to the Base DSP unit.  The second ferrite bead needs 
to be attached 5 inches (13 centimeters) from the end of the cable that will 
attach to the antenna.   
 
NOTE:  

The Antenna Receiver provides room for the ferrite to be placed in 
the antenna casing, underneath the mount plate.  If running the 
cable through the  Network Cable Opening in the mount plate the 
ferrite must be installed after the cable has been pulled through.  
Otherwise it will not fit through the opening.   

 

5 in 

13 cm 

1/4 – 3/8 in 

7 – 10 mm