Microheat MHFOB72 Manuale Utente
10/31/2006
11
Installation / Operation Manual HotShot MH-35 RF
Warning:
The unit must be primed prior to operation. To do this, turn ignition on and activate the
washers via the OEM washer button. The system is primed when washer fluid begins to spraying out the
nozzles.
Note: If the prior steps are not followed, the HotShot unit could overheat and cause internal
damage.
nozzles.
Note: If the prior steps are not followed, the HotShot unit could overheat and cause internal
damage.
8 Secure all cables and all wires away from hot engine
parts and moving objects with provided zip ties.
9
The underhood unit uses the car battery as its power
source which enables the underhood MH 35 RF Unit
to stay on in receive mode indefinitely. The FOB will
use 3 Triple “A” batteries as its power source. To
activate the initial communications between the two
units is follow:
source which enables the underhood MH 35 RF Unit
to stay on in receive mode indefinitely. The FOB will
use 3 Triple “A” batteries as its power source. To
activate the initial communications between the two
units is follow:
• Once the MH 35 RF unit is completely
Installed.
• Start
engine
• Within 30 seconds after starting engine you
need to be within perimeter of 3 meters of the
MH 35 Unit.
MH 35 Unit.
• Take FOB and depress both the Thermometer
and Windshield Wiper buttons at the same
time.
time.
• Upon depressing the two FOB buttons the
lights above each button will come on.
• After 5 seconds the light’s will start flashing
once per second (at this point you can stop
depressing the two buttons) it will now take a
few more seconds until both light’s shut off. At
this point the FOB and the MH 35 RF unit are
married to each other.
depressing the two buttons) it will now take a
few more seconds until both light’s shut off. At
this point the FOB and the MH 35 RF unit are
married to each other.