TP-Link Technologies Co. Ltd. TDW9980V1 Manuale Utente

Pagina di 123
 
 
This is a class B product. In a domestic environment, this product may cause radio interference, in 
which case the user may be required to take adequate measures. 
National Restrictions 
This device is intended for home and office use in all EU countries (and other countries following 
the EU directive 1999/5/EC) without any limitation except for the countries mentioned below: 
Country 
Restriction 
Reason/remark 
Bulgaria 
None 
General authorization required for outdoor use and 
public service 
France 
Outdoor use limited to 10 
mW e.i.r.p. within the band 
2454-2483.5 MHz 
Military Radiolocation use. Refarming of the 2.4 GHz 
band has been ongoing in recent years to allow current 
relaxed regulation. Full implementation planned 2012 
Italy 
None 
If used outside of own premises, general authorization is 
required 
Luxembourg 
None 
General authorization required for network and service 
supply(not for spectrum) 
Norway 
Implemented 
This subsection does not apply for the geographical area 
within a radius of 20 km from the centre of Ny-Ålesund 
Russian Federation 
None 
Only for indoor applications 
Note: Please don’t use the product outdoors in France.
 
Canadian Compliance Statement 
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject 
to the following two conditions:   
(1)This device may not cause interference, and   
(2)This device must accept any interference, including interference that may cause undesired 
operation of the device. 
Cet appareil est conforme aux norms CNR exemptes de licence d’Industrie Canada. Le 
fonctionnement est soumis aux deux conditions suivantes:   
(1)cet appareil ne doit pas provoquer d’interférences et   
(2)cet appareil doit accepter toute interférence, y compris celles susceptibles de provoquer un 
fonctionnement non souhaité de l’appareil. 
This device has been designed to operate with the antennas listed below, and having a maximum 
gain of 5  dBi. Antennas not included in this list or having a gain greater than 5  dBi are strictly 
prohibited for use with this device. The required antenna impedance is 50 ohms.   
To reduce potential radio interference to other users, the antenna type and its gain should be so 
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for 
successful communication.