TP-Link Technologies Co. Ltd. WA60XG Manuale Utente

 

 

14

1.  Configure the Operating Mode of the TL-WA601G Access Points.   

• 

Configure AP1 on LAN Segment 1 in Access Point mode. 

• 

Configure AP2 in Repeater mode with the MAC address of its root AP (AP1). 

• 

Configure AP3 in Repeater mode with the MAC address of its root AP (AP2).   

 

Figure 3-7 Wireless repeating 

2. 

Verify the wireless security parameters for all access points, if any. 

 

3.  Verify connectivity across the LANs. A computer on any LAN segment should be able to 

connect to the Internet or share files and printers with any other PCs or servers connected to 
any of the three WLAN segments. 

)

You can extend this repeating by adding up to 2 additional TL-WA601Gs configured in repeater 
mode. However, since Repeater configurations communicate in half-duplex mode, the bandwidth 
decreases as you add Repeaters to the network. Also, you can extend the range of the wireless 
network with wireless antenna accessories. 

¾

 

 

This mode bridges the AP and another AP also in bridge mode to 

connect two wired LANs. Please input the MAC address of the other AP in the field of MAC of 
AP. 

• 

With AP mode: If you select this option, you AP will also support AP mode when it is in 
Bridge(Point to Point) mode. 

Here is an example of how to configure Point-to-Point Bridge. Please do the following: 

 

Figure 3-8 Point to Point Bridge 

1.  Configure the TL-WA601G (AP1) on LAN Segment 1 in Point-to-Point Bridge mode.