TP-Link Technologies Co. Ltd. WA860REV4 Manuale Utente
30
FAQ
Q1. How do I reset the extender to its factory default settings?
• With the extender powered on, use a pin to press the
RESET
button until all the LEDs
turn on momentarily and then release the button.
• Log in to the extender’s web management page. Go to
Settings
>
System Tools
>
Restore & Backup
and click
Factory Restore
.
Q2. What should I do if I forget my login password?
Refer to FAQ > Q1 to reset the extender, and create a new password for future login
attempts.
attempts.
Note: The extender must be reconfigured after a reset to access internet. Please note down your new
login password for future use.
Q3. What should I do if I forget my wireless password?
The factory default wireless password is printed on the label of the extender.
If the password has been altered, please connect your computer to the extender using
an Ethernet cable and follow the steps below:
1. Visit
If the password has been altered, please connect your computer to the extender using
an Ethernet cable and follow the steps below:
1. Visit
http://tplinkrepeater.net
, and log in with the password you set for the extender.
2. Go to
Settings
>
Wireless
>
Wireless Settings
to retrieve or reset your wireless
password.
Q4. What should I do if I cannot access the web management page?
This can happen for a variety of reasons. Please try the following.
• If your computer is wirelessly connected, make sure that you have connected to the
• If your computer is wirelessly connected, make sure that you have connected to the
extender’s SSID.
• If your computer is connected via an Ethernet cable, please make sure that the
connection is stable.
• Make sure your computer is set to obtain an IP address and DNS server address
automatically.
• Verify that
http://tplinkrepeater.net
or
http://192.168.0.254
is correctly entered in the
web browser and press
Enter
.
• Use the IP address to access the extender. The default IP is
192.168.0.254
. If the
extender is connected to the router, you should go to your router’s DHCP client list to
obtain the extender’s current IP address.
obtain the extender’s current IP address.
• Reset the extender and try again.
Q5. I have enabled wireless MAC filter, wireless access control, or access
control list (ACL) on my router. What should I do beofre configuring