Compex Systems Pte Ltd 10-WLE200NX Manuale Utente

 

3

•   One WL84E WLAN Card   
•   WL84E Manual   
•      WL84E Drives and Manual on CD-ROM   

Chapter 2 Installation   

2.1 Hardware Installation   

To install the adapter, follow these steps listed below:   

 

1. Turn off your desktop PC and disconnect the power.   

 

2. Remove your PC case and locate an available PCI slot on the mianboard. 
Remove the metal slot cover on the back of the PC. Check with your computer 
manufacturer for instructions if needed.   

 

3. Slide the PCI Adapter into the PCI slot. Make sure that all of its pins are 
touching the slot's contacts. Once the adapter is firmly in place, secure its 
fastening tab to your PC's chassis with a mounting screw. Then, close your PC 
case.  

 

4. Reconnect your PC’s power and turn on your desktop PC.   

2.2 Software Installation   

2.2.1 Overview   

The Adapter’s Setup Wizard will guide you through the Installation procedure for 
Windows 2000, XP and Vista. The Setup Wizard will install the WL84E Wireless N 
Client Utility (11NWCU) and drivers. 

 

When you install the hardware prior to before installing the software, the system will 
prompt “Found New Hardware Wizard”, click Cancel, and run the Setup Wizard 
program on the CD-ROM.   

The Setup steps for Windows 7, XP and Vista are very similar. The following setup 
steps are for Windows XP.   

2.2.2 Software Installation for Windows XP   

 

1. Insert the Resource CD into your CD-ROM drive, and open the folder with the 
same name as your product. Then double-click Setup.exe in the proper folder 
according to your operating system to start the installation. After that, Figure 2-1 
will appear. You can click Cancel to end the installation in the screen above.