KCodes Corporation KCODES-604N Manuale Utente

 
 

 
 

18

 

 
D.  Now, PC will detect the plug-in of the USB device. The “connect” operation is a 

software operation that simulates an actual USB device plug-in. That is to say, 
when you do a “connect” operation in the Control Center, PC can then detect a 
USB device’s plug-in, although actually you do not plug in any USB device. 

E.  Then, just use the USB device as if it is connected directly to your PC’s USB port. 
F.  After you finish using the USB device, click the USB device in the Control Center 

and then click the “Disconnect” button to disconnect the USB device. Other PCs 
can not “Connect” the USB device until you “Disconnect” that USB device. That is 
to say, only one PC is allowed to connect the USB device at the same time. 

 

 

 
The method described in section 4.5 is so-called manual-connect, which means users 
must manually connect the USB device before using that device, and must manually 
disconnect the USB device after using the device, otherwise nobody else can connect 
this device. However, for printers and scanners (and MFPs), the USB device server 
supports auto-connect so users don’t need to manually connect/disconnect. This and 
the next sections show you how to do this. 
 
After the driver is installed as described in section 4.4, you can see a newly created 
printer in the Control Panel’s “Printers and Faxes”. Follow the steps below to do a 
NetUSB auto-connect printing. 
 
A.  In the Control Center, click the USB device server that has the desired printer (or