KCodes Corporation KCODES-604N Manuale Utente

 
 

 
 

7

 

 

 

1.  Make sure that your USB devices are switched off and that the Server’s Power 

Adapter is disconnected. 

 
2.  Connect the USB devices to the USB ports with the USB cables.   

 

3.  Connect the Server to the network with a twisted-pair category 5 cable, 

10baseT or 100baseTX.   

 
4.  Turn on the USB devices and make sure it is ready for use.   

 

5.  Connect the Power Adapter to the Server. The power indicator will light up and 

USB1 and USB2 indicators will flash in turn. (For KCodes 601/601n, only USB1 
indicator will flash.) When the Link indicator lights up, the Server is correctly 
connected to the network. When USB1 and USB2 indicators stop flashing, the 
Server starts to work normally.   

 

 
This section only applies to KCodes 601n/604n. 
 

„  Before you can access wireless network, wireless parameters should be set 

correctly.  You have to setup the first wireless parameter set through LAN 
(wired) connection. 

„  Wireless access can be set as infrastructure (station) mode, which need an 

access point to route network messages with the same SSID. 

„  Wireless access can be secured by WEP (64/128), WPA-PSA (TKIP/AES), and 

WPA2-PSK (AES). 

„  In infrastructure mode, if network administrator wants to change any security 

related parameters, KCodes 601n/604n should be changed first, and then 
access point.    If parameters mismatch causes wireless access is not allowed, 
you have to modify those parameters through LAN connection. 

„  In infrastructure mode, the maximal transfer rate is 54 MBits depending on 

access point’s capability.   

 
3.2.2  Set Wireless Configuration Using Control Center 

1.  Install USB Device Server Control Center. It is available in the KCodes 

601n/604n USB Device Server Product CD. 

2.  Start USB Device Server Control Center and Auto-searching USB device server 

window will appear.