Hantech Corporation WG100R Manuale Utente

 

16

-  the  physical  address  of  the  router,  as  seen  from  the  LAN.  The value can't be 

changed. 

Enter the IP address of your router in dotted-decimal notation (factory default: 

192.168.1.254). 

An address code that determines the size of the network. Normally use 255.255.255.0 

as the subnet mask. 

 You can select None,Client,Serve. The router is set up by default as a DHCP (Dynamic Host 

Configuration Protocol) server, which provides the TCP/IP configuration for all the PCs that are 
connected to the router on the LAN. 

 This field specifies the first of the addresses in the IP address pool. 

 The IEEE 802.1D Spanning Tree Algorithm (STA) ,loop prevention and redundant 

link configuration. You  can select disable or enable.if your mode was set WDS or AP+WDS, this item 
should be set “enable” 

you can enter a MAC,Then click clone. 

 

This page is used to configure the parameters for Internet network which connects to the WAN 

port of your Access Point. Here you may change the access method to static IP, DHCP, PPPoE or PPTP 
by click the item value of WAN Access type. 

you can refer to 3.2 Quick Installation Guide. 

you can select continous o, connect on demand, manual.  

when connection type is connect on demand,you can set idle time. 

The normal MTU (Maximum Transmission Unit) value for most Ethernet networks is 1492 

Bytes. For some ISPs you need to reduce the MTU. But this is rarely required, and should not be 
done unless you are sure it is necessary for your ISP connection. 

You can select Attain DNS Automatically or Set DNS Manually 

:  if you wang  clone, input MAC Address