Omnilink Systems Inc. OL300G Manuale Utente
Omnilink User Guide
12
12-18-08 v2.0
TECHNICAL SUPPORT
(800) 297-0128
(678) 624-5919
techsupport@Omnilinksystems.com
FULFILLMENT
(678) 624-5944
fulfillment@Omnilinksystems.com
Warning: Changes or modifications to this device not expressly approved by Omnilink Systems could void the
user’s authority to operate the equipment.
FCC Notices:
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two Conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference recievec, including interference that may cause undesired
(2) this device must accept any interference recievec, including interference that may cause undesired
operation.
Omnilink Orion – Contacting Omnilink
Omnilink Orion – Notifications