Dorman Products Inc. DORM14 Manuale Utente
ALL KEY FOBS MUST BE PRESENT AND REPROGRAMMED WHEN PROGRAMMING NEW FOBS
Programming Instructions:
1. Close and lock all doors with the driver's side power lock / unlock switch located
on driver’s door panel.
2. Insert key into ignition and remove it from the ignition cylinder at least 10 times
within 10 seconds, if successful your hazard lamps will flash.
ATTENTION*** Withdraw key completely from ignition cylinder each time. If
this procedure is performed to fast, system will not enter programming mode.
3. Insert key into ignition and turn to the ACC position.
4. Within 5 seconds, push ANY button on the keyless remote. Your hazard lamps
will flash. NOTE: Do not press the button on the remote more than one time or the
programming will not be successful.
5. To program all remaining new or old remotes, Unlock then Lock all doors
using the switch on the driver’s door panel and within 5 seconds press ANY button on the next
remote. Your hazard lamps will flash. Repeat this step for each remote (including any
existing remotes).
6. Turn key to the off position, remove key from the ignition. Unlock door using switch on
door panel and open driver’s door.
7. Test remote(s).
on driver’s door panel.
2. Insert key into ignition and remove it from the ignition cylinder at least 10 times
within 10 seconds, if successful your hazard lamps will flash.
ATTENTION*** Withdraw key completely from ignition cylinder each time. If
this procedure is performed to fast, system will not enter programming mode.
3. Insert key into ignition and turn to the ACC position.
4. Within 5 seconds, push ANY button on the keyless remote. Your hazard lamps
will flash. NOTE: Do not press the button on the remote more than one time or the
programming will not be successful.
5. To program all remaining new or old remotes, Unlock then Lock all doors
using the switch on the driver’s door panel and within 5 seconds press ANY button on the next
remote. Your hazard lamps will flash. Repeat this step for each remote (including any
existing remotes).
6. Turn key to the off position, remove key from the ignition. Unlock door using switch on
door panel and open driver’s door.
7. Test remote(s).
FCC WARNING
Statement 15.19(a)(3):
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. Changes or modifications not expressly approved by Dorman Products Inc. could void the user’s authority to operate the equipment.
operation. Changes or modifications not expressly approved by Dorman Products Inc. could void the user’s authority to operate the equipment.
IC WARNING
The term IC before the Certification/Registration number only signifies that the Industry Canada technical specifications were met.