Dorman Products Inc. DORM27 Manuale Utente

ALL KEY FOBS MUST BE PRESENT AND REPROGRAMMED WHEN PROGRAMMING NEW FOBS 
 
Programming Instructions: 
1)  

Make sure all doors are unlocked when you begin. 

2)  

Turn the ignition to the ON position. 

3)  

Press the LOCK or UNLOCK button on the remote. 

4)  

Turn the ignition to the ACCESSORY or LOCK . 

5)  

Turn the ignition to ON 

6)  

Press the lock or UNLOCK button on same remote. 

7)  

Turn the ignition to ACCESSORY or LOCK. 

8)  

Turn the ignition to ON 

9)  

Press the LOCK or UNLOCK button on the same remote 

10) 

Turn the ignition to ACCESSORY or LOCK 

11)  

Turn the ignition to ON 

12)  

Press the LOCK or UNLOCK button on the same remote. Make sure the door locks cycle to indicate that the system has entered 
programming mode. 

13)  

Press the lock button on each remote that you want programmed. Make sure the doors locks cycle each time to indicate that remote has 
been accepted. The system will accept up to three remotes. 

14)  

Turn the ignition to LOCK to exit the programming remote. 

15)  

Test all remotes. 

 
FCC WARNING 
 
15.19:  
This device complies with part 15 of the fcc rules. Operation Is subject to the following two conditions: (1) this device may not cause harmful 
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 
15.21: 
Note: The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such 
modifications could void the user’s authority to operate the equipment. 
 
IC WARNING 
 
FVIN 63999358IC 
 
The term IC before the Certification/Registration number only signifies that the Industry Canada technical specifications were met. This device 
complies with Industry Canada’s license-exempt RSSs Operation is subject to the following two conditions: (1) this device may not cause 
interference, and (2) this device must accept any interference including interference that may cause undesired operation of the device.  
 

Le terme IC avant le numéro de certification / enregistrement ne signifie que les spécifications techniques d'Industrie Canada ont été remplies. Cet 
appareil Est conforme aux flux RSS exemptés de licence d'Industrie Canada Le fonctionnement est soumis aux deux conditions suivantes: (1) cet 
appareil ne peut pas provoquer Les interférences et (2) cet appareil doit accepter toute interférence, y compris les interférences susceptibles de 
provoquer un fonctionnement indésirable de l'appareil.