Dorman Products Inc. DORM31 Manuale Utente
ALL KEY FOBS MUST BE PRESENT AND REPROGRAMMED WHEN PROGRAMMING NEW FOBS
Programming Instructions:
1) From inside the car shut the doors and make sure they are unlocked.
2) Turn on the ignition (but do not start the car just the ignition).
3) Press the lock button on the remote.
4) Turn key to the accessory ON position (your radio works in this mode).
5) Turn on the ignition (but do not start the car just the ignition).
6) Press the lock button on the remote .
7) Turn vehicle key to the accessory ON position (Your radio works in this mode)
8) Turn on the ignition (do not turn on the car just the ignition)
9) Press the lock button on remote.
10) Turn key to the accessory ON position (your radio works in this mode).
11) Turn on the ignition (but do not start the car just the ignition).
12) Press the lock button on the remote, the locks should chirp to indicate that the programming mode was entered successfully.
13) Press the LOCK button on remote, the doors should chirp again to confirm programming
Press the lock button on each of the remaining remotes to be programmed (one at a time).
14) Turn off the car fully and try locking/unlocking with remote.
2) Turn on the ignition (but do not start the car just the ignition).
3) Press the lock button on the remote.
4) Turn key to the accessory ON position (your radio works in this mode).
5) Turn on the ignition (but do not start the car just the ignition).
6) Press the lock button on the remote .
7) Turn vehicle key to the accessory ON position (Your radio works in this mode)
8) Turn on the ignition (do not turn on the car just the ignition)
9) Press the lock button on remote.
10) Turn key to the accessory ON position (your radio works in this mode).
11) Turn on the ignition (but do not start the car just the ignition).
12) Press the lock button on the remote, the locks should chirp to indicate that the programming mode was entered successfully.
13) Press the LOCK button on remote, the doors should chirp again to confirm programming
Press the lock button on each of the remaining remotes to be programmed (one at a time).
14) Turn off the car fully and try locking/unlocking with remote.
FCC WARNING
Statement 15.19(a)(3):
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. Changes or modifications not expressly approved by Dorman Products Inc. could void the user’s authority to operate the equipment.
operation. Changes or modifications not expressly approved by Dorman Products Inc. could void the user’s authority to operate the equipment.
FCC Part 15.21:
THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR
COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.