Dorman Products Inc. DORM39 Manuale Utente
ALL KEY FOBS MUST BE PRESENT AND REPROGRAMMED WHEN PROGRAMMING NEW FOBS
Programming Instructions:
Be sure to have all currently programmed remotes available for this process. Any remotes not present will be erased.
Turn the ignition off
Plug the programming dongle into the OBD-2 port.
Using a valid remote, press lock and then unlock.
Wait 5 seconds. The programmer will beep a short beep and the green LED will blink.
Wait 20 seconds. The programmer will begin to flash the red LED every second to indicate security access is in progress.
After 10 minutes the programmer will beep and flash the green light to indicate security access has been gained.
Press the button to erase all stored key data. This will erase all currently programmed keys to the vehicle. All previously programmed keys must be
relearned during this process.
The programmer will beep a long beep and flash the green LED to indicate that all keys have been erased.
Turn the ignition off
Plug the programming dongle into the OBD-2 port.
Using a valid remote, press lock and then unlock.
Wait 5 seconds. The programmer will beep a short beep and the green LED will blink.
Wait 20 seconds. The programmer will begin to flash the red LED every second to indicate security access is in progress.
After 10 minutes the programmer will beep and flash the green light to indicate security access has been gained.
Press the button to erase all stored key data. This will erase all currently programmed keys to the vehicle. All previously programmed keys must be
relearned during this process.
The programmer will beep a long beep and flash the green LED to indicate that all keys have been erased.
Place a remote into the programming socket, then press the button on the programming dongle.
The programmer will beep a short beep and the LED will remain off to indicate that the remote has been detected in the socket.
The red LED will blink until the remote is programmed.
The programmer will beep a long beep and the green LED will turn on to indicate that the key has been successfully programmed.
Remove the programmed remote from the socket. Test the remote by pressing lock/unlock.
Place the next remote into the programming socket, then press the button on the programming dongle.
The programmer will beep a short beep and the LED will remain off to indicate that the remote has been detected in the socket.
The red LED will blink until the remote is programmed.
The programmer will beep a long beep and the green LED will turn on to indicate that the key has been successfully programmed.
Remove the programmed remote from the socket. Test the remote by pressing lock/unlock.
Repeat steps 15 through 19 for any additional remotes. A maximum of 4 remotes may be learned to the vehicle.
When all remotes have been programmed, unplug the programmer from the OBD-2 port.
The programmer will beep a short beep and the LED will remain off to indicate that the remote has been detected in the socket.
The red LED will blink until the remote is programmed.
The programmer will beep a long beep and the green LED will turn on to indicate that the key has been successfully programmed.
Remove the programmed remote from the socket. Test the remote by pressing lock/unlock.
Place the next remote into the programming socket, then press the button on the programming dongle.
The programmer will beep a short beep and the LED will remain off to indicate that the remote has been detected in the socket.
The red LED will blink until the remote is programmed.
The programmer will beep a long beep and the green LED will turn on to indicate that the key has been successfully programmed.
Remove the programmed remote from the socket. Test the remote by pressing lock/unlock.
Repeat steps 15 through 19 for any additional remotes. A maximum of 4 remotes may be learned to the vehicle.
When all remotes have been programmed, unplug the programmer from the OBD-2 port.