Acrox Technologies Co. Ltd. MU0010340 Manuale Utente
Troubleshooting
Troubleshooting
Mouse does not work upon installation
Try one or more of the following:
l For optimal performance, place the receiver at least eight inches or 20
centimeters away from the mouse or other electrical devices, such as the
computer, the computer monitor, or external drive.
l Make sure you have installed the batteries correctly.
l Check the Channel Switch on both Mouse and Receiver is set to the same
l Check the Channel Switch on both Mouse and Receiver is set to the same
channel No ( for 2 Channel Model Only)..
l If you are working on a metallic surface, try using a mouse pad and turning the
receiver on its side for better reception
Cordless 3D Optical Wheel Mouse
With
Advanced Human Body Detect Technology
USER'S GUIDE
Mous e Not Detected
When using the mouse, it may not be detected by the computer, To remedy this
problem, try the following
l Make sure the receiver cable is plugged into the right mouse port.
l Make sure your mouse port has the proper configuration. Refer to your computer
l Make sure the receiver cable is plugged into the right mouse port.
l Make sure your mouse port has the proper configuration. Refer to your computer
documentation for the correct port configuration.
l You may have other system devices(eg. a LAN card) that conflict with your
mouse . Check the IRQ/address settings of these devices for conflicts, and
change the settings as required.
The Screen Cursors Does Not Move Properly
l Change the position of your radio receiver, because it may be too far from the
mouse ; or the computer monitor, or a large metal object may be interfering with
the receiver's radio reception. Try moving the receiver and/or mouse to improve
reception.
the receiver's radio reception. Try moving the receiver and/or mouse to improve
reception.
l Make sure that the battery indicator is NOT lit on. Replace batteries if the low
battery indicator is lit on.
l You may also need to change the channel / ID for the mouse, Press the Connect
button on the receiver, then press the Connect button on the mouse.
l If your tabletop surface is red in color or is highly reflective like a mirror, your
tabletop surface may be interfering with the optical sensor of the mouse, Try
using a mouse pad, or use the mouse on a different tabletop surface.
using a mouse pad, or use the mouse on a different tabletop surface.
l If you had stop to operate the mouse for a while, the Mouse maybe in Suspend
Mode. To wake up the mouse, please press anyone key on the mouse.
CAUTION To use this mouse properly, please read
the user's guide before installation
6
For 1 Ch, 256 ID and 2 Ch, 256 ID Models