Thales e-Transactions Inc. DATATAC001 Manuale Utente
Revision 1.0
ARTEMA DataTAC
8
Installation Manual
THIS INFORMATION IS PROPRIETARY INFORMATION OF THALES
e-TRANSACTIONS AND MAY NOT BE USED, COPIED, DISCLOSED
OR DIVULGED, IN WHOLE OR IN PART, FOR ANY PURPOSE BY
ANY PERSON WITHOUT THE WRITTEN APPROVAL OF THALES
e-TRANSACTIONS INC.
e-TRANSACTIONS AND MAY NOT BE USED, COPIED, DISCLOSED
OR DIVULGED, IN WHOLE OR IN PART, FOR ANY PURPOSE BY
ANY PERSON WITHOUT THE WRITTEN APPROVAL OF THALES
e-TRANSACTIONS INC.
E-TRANSACTIONS, INC.
- The printer will work only if the casing is closed.
- Switch on the terminal, by pressing the "OK" key, and draw an inch of paper to
- Switch on the terminal, by pressing the "OK" key, and draw an inch of paper to
check that the roll is correctly placed in its casing.
- Tear off the excess paper by pulling the paper towards the front of the terminal.
4.4 Connecting to the power supply
- Plug the base power cord into a wall outlet (115V), and verify that the green
indicator light on the base is lit.
The outlet needs to be close to the terminal and within reach, in order to be
quickly disconnected, if necessary.
quickly disconnected, if necessary.
4.5 Charging The ARTEMA
Before using Artema for the first time, leave the handset on the base and let it
charge for 8 hours in order to fully charge the battery pack.
charge for 8 hours in order to fully charge the battery pack.
- After a charging cycle, an icon on the terminal indicates the battery charge level
- In order for you to run a large number of transactions without the base
- We recommend that you change battery packs every two years.
- Use only Thales certified battery packs.
- In order for you to run a large number of transactions without the base
- We recommend that you change battery packs every two years.
- Use only Thales certified battery packs.