Arescom Inc. AG2000S Manuale Utente

AG2000Series Software User’s Guide

June, 2002

9

AG2000 offers a platform-independent, HTML-based GUI (graphical user interface) 
to simplify the setup and configuration of your AG2000 by using web browser. All 
the PCs on your LAN network need to be set up properly in order to communicate 
with the AG2000. Please carefully read and follow the instructions below before you 
start configuring your AG2000: 

If you have a wireless device installed on your computer and want to use it to connect 
to the AG2000, set its channel number to 6 and SSID to arescom.

NOTE: The SSID is case-sensitive and set the operating mode to Infrastructure.

Since the AG2000 can automatically assign IP address, subnet mask and gateway IP 
address to your network PCs through its DHCP server, we highly recommend that 
you configure your TCP/IP Properties to “Obtain an IP address automatically”. Select 
the proper network adapter, either an Ethernet or a Wireless Adapter, that you are 
using to connect to the AG2000.

NOTE: You CANNOT connect a PC to the AG2000 through an Ethernet networking card 

and a wireless device installed in your PC at the same time

Follow the instructions below to complete the setup:

Step 1. Click Start -> Settings -> Control Panel.

Step 2. Double-click Network.

Step 3. Double-click TCP/IP -> XXXX Ethernet/Wireless Adapters (“XXXX” is the maker 

of your Ethernet card).

Step 4. Select the radio button next to Obtain an IP address automatically.

Step 5. Click the Gateway tab and remove all previously installed gateways and click OK.

Step 6. Click OK again.

Step 7. Restart your computer.

Step 1. Right-click the My Network Places icon in the desktop.

Step 2. Click Properties.

Step 3. Right-click Local Area Connection.

Step 4. Click Properties.

Step 5. Double-click Internet Protocol (TCP/IP).

Step 6. Select the radio button next to Obtain an IP address automatically and click OK.

Step 7. Click OK again.