Silex Technology 90148 Manuale Utente
There are three ways to configure the EtherWind:
1. The EtherWind CD includes WP-Admin, for easy installation over a wireless
connection (see chapter 2 of the User’s Guide).
connection (see chapter 2 of the User’s Guide).
2. If you hold down the button while you are powering up, the print server will
configure itself to Ad-Hoc (802.11) mode with an SSID of printer (lower-case)
and an IP address of 192.0.0.192. You can configure your PC to the same set-
tings, and put it on the same TCP/IP subnet (ie: configure your PC to have an
IP address of 192.0.0.100), and configure the EtherWind using your web brows-
er (type http://192.0.0.192 in the address bar of your browser).
configure itself to Ad-Hoc (802.11) mode with an SSID of printer (lower-case)
and an IP address of 192.0.0.192. You can configure your PC to the same set-
tings, and put it on the same TCP/IP subnet (ie: configure your PC to have an
IP address of 192.0.0.100), and configure the EtherWind using your web brows-
er (type http://192.0.0.192 in the address bar of your browser).
3. Use a standard null modem DB9F Serial Cable to configure the print server.
Below is a quick set of instructions for configuring the basic wireless and net-
work settings. Text might come up while in your console session to show you
what the print server and network are doing, you can ignore these and type
through these.
Below is a quick set of instructions for configuring the basic wireless and net-
work settings. Text might come up while in your console session to show you
what the print server and network are doing, you can ignore these and type
through these.
To connect to the TROY Wireless Print Server using the Serial Port, use a ter-
minal emulator (like Windows Hyperterminal) with the settings:
Speed: 115200
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
Hit ENTER a couple times. When you get the "Local>" prompt, you are ready to
enter commands.
minal emulator (like Windows Hyperterminal) with the settings:
Speed: 115200
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
Hit ENTER a couple times. When you get the "Local>" prompt, you are ready to
enter commands.
Local> set en mo mode
Where mode is either IN for Infrastructure (Access Point) mode, AD for Ad-Hoc
(802.11 peer-to-peer) mode (PS for Pseudo Ad-Hoc Mode for older proprietary
Ad-Hoc implementations)
Where mode is either IN for Infrastructure (Access Point) mode, AD for Ad-Hoc
(802.11 peer-to-peer) mode (PS for Pseudo Ad-Hoc Mode for older proprietary
Ad-Hoc implementations)
Local> set en ss ssid
Where ssid is the SSID (Service Set Identifier) you want the print server to be.
Surround the SSID with "" (Double Quotes) if you use a space in it.
Where ssid is the SSID (Service Set Identifier) you want the print server to be.
Surround the SSID with "" (Double Quotes) if you use a space in it.
Quick Setup