RadioFrame Networks Inc DH2 Manuale Utente

RadioFrame System 

RFN_3.1 Beta

 

5MHz/1PPs  OUT 

BNC connector for timing interface 

GPS ANT 

GPS antenna connection 

 

Each card installed in the front and back of the NCU has two LEDs: Power (top) 
indicates power, and Status (lower) indicates the status of the card. Each RJ45 
port has two LEDs: Link (right) indicates Ethernet connectivity, and Activity (left) 
blinks to indicate Ethernet activity. All LEDs should light as green. For all other 
conditions, refer to the following table. 

Power and Status LEDs 
for cards installed in 
front or back of NCU are 
not lit 

no power to NCU 

 

Verify that the power cord is 
installed and properly seated. 

 

Verify that the power source is 
operational (120VAC or  
–48VDC). 

 

Contact Customer Support. 

Status LED is red—top 
front card only 

timing source not 
available 

 

Connect the timing source. In 
iDEN installations, this is usually 
the iSC-3. In some cases, the 
timing source is the GPS 
antenna. 

 

Check all connections. 

 failed 

initialization 

 

Reboot the system: unplug the 
NCU, and plug it in again. Boot 
up may take several minutes. 

 

fan is not working 

 

Verify that the fan is operational. 

 

If the fan is not working, unplug 
the NCU and contact Customer 
Support. 

Status LED is red—any 
card 

card is not operational 

 

Remove and reseat card. 

 

Contact Customer Support. 

RJ45 port Link and 
Activity LEDs are not lit, 
or the Activity LED is not 
blinking 

connection is not being 
made between RFS 
components 

 

For the affected port, verify that 
all cabling between components 
is properly connected.