RadioFrame Networks Inc MCSERIESHP10 Manuale Utente
MC-Series High-Power System
Scheduled and Unscheduled Maintenance
998--01 Rev X1
RadioFrame Networks, Inc.
CONFIDENTIAL AND PROPRIETARY 93
Figure 59 Front View of the RadioBlade Shelf (RBS)
1 Take the RadioBlade transceiver out of service by locking it (refer to the procedure
in section 6.2.2.3: “Locking and Unlocking a RadioBlade Transceiver”).
The RBS is divided into three groups (A, B and C) from left to right. Slots in each group are
numbered as follows, from front to back:
numbered as follows, from front to back:
Group A: slots 1 through 8
Group B: slots 9 through 16
Group C: slots 17 through 24
2 Pull out the RBS using the handle on the front of the unit.
3 Remove the RadioBlade transceiver that is to be replaced (see Figure 60).
3 Remove the RadioBlade transceiver that is to be replaced (see Figure 60).
Using the SMA torque wrench, disconnect the Rx and Tx cables from the RadioBlade
transceiver. Then loosen the screw of the lockdown strap covering the RadioBlade
transceiver, and remove the strap and screw and place them aside. Then gently lift and
remove the RadioBlade transceiver from the slot in the RBS backplane. Place the
RadioBlade transceiver in anti-static packaging for shipment.
transceiver. Then loosen the screw of the lockdown strap covering the RadioBlade
transceiver, and remove the strap and screw and place them aside. Then gently lift and
remove the RadioBlade transceiver from the slot in the RBS backplane. Place the
RadioBlade transceiver in anti-static packaging for shipment.
Figure 60 RadioBlade Transceiver in Place
lockdown strap
4 Un-package the replacement RadioBlade transceiver to be inserted into the RBS.
5 Insert the RadioBlade transceiver into the specified slot in the RBS until the
5 Insert the RadioBlade transceiver into the specified slot in the RBS until the
connector seats firmly into the backplane of the RBS.
6 Place the lockdown strap over the RadioBlade transceiver by inserting the two feet
on the strap into the slots on the RBS backplane, and then hand tighten the screw
into place.
into place.