Honeywell International Inc. WFSLCDUI Manuale Utente

54

PRELIMINARY: Firelite Wireless Sensor Network P/N LS10036-000FL-E:N0  10/10/2013

Wireless Display Driver (W-DIS-D)

The wireless events are sent to the FACP as generic trouble or supervisory events by the W-GATE 
and the details of the specific events are sent to the ANN-80 by the W-DIS-D. The FACP piezo 
activates for the first trouble event and the first supervisory event.  The FACP piezo will not acti-
vate for additional trouble events or supervisory events when the initial event is still active. The 
ANN-80 piezo will not activate for the first event but will sound for each event after the initial 
event.

Use the ACK button to acknowledge the piezo.  The reset function can be enabled in the ANN-80 
using the key switch.  To enable the reset button,  insert the key into the key switch and turn the key 
switch counter clockwise to the ON position. 

To silence the buzzer, press the ACK key on the ANN-80 (Figure 3.6).

The wireless specific events are related to the wireless W-GATE and devices. These events are dis-
played and notified on the FACP and N-ANN 80 in the form of messages. These messages are dis-
played based on their occurrences. You can scroll through the messages using the up arrow and 
down arrow buttons. 

The message, ‘RF COMM LOSS’ is displayed when the W-DIS-D is not in the network.  The mes-
sage displayed is if the W-DIS-D is in Bootloader, factory default, or profile assigned state but not 
a part of a mesh network.  RF COMM LOSS is a tracking event that will clear once the W-DIS-D 
joins a mesh network.

The message, ‘MESH FORMATION IN PROGRESS’ is displayed when the network is in mesh 
formation mode.   Mesh Formation in Progress is a tracking trouble that will clear once the W-
GATE exits mesh formation mode.

NOTE: The ANN-80 must join the network to show this message. If it is not present in the 
network, ‘RF Comm Loss’ message is displayed.