Honeywell International Inc. WFSLCDUI Manuale Utente
PRELIMINARY: Firelite Wireless Sensor Network P/N LS10036-000FL-E:N0 10/10/2013
81
Description
Site Survey
Results of Link Test
Once you have introduced the two devices, the devices start communicating and the link quality
test is started. The blinking pattern of the LEDs in the device 102 communicates the results of the
link test. To repeat the test, follow the steps 1 to 4. The link test results stay for 5 minutes and then
the RF test begins. You can repeat the test any number of times; the only condition being that the
next test should be conducted within five minutes of the last concluded test. Refer to Table A.1,
"Link Test Results-LED Pattern" for LED patterns that convey the link quality results.
test is started. The blinking pattern of the LEDs in the device 102 communicates the results of the
link test. To repeat the test, follow the steps 1 to 4. The link test results stay for 5 minutes and then
the RF test begins. You can repeat the test any number of times; the only condition being that the
next test should be conducted within five minutes of the last concluded test. Refer to Table A.1,
"Link Test Results-LED Pattern" for LED patterns that convey the link quality results.
This concludes the link test and the RF Scan test starts. The devices addressed 101 or higher,
transition to RF Scan test. On devices addressed below 100, the link test results stay until the bat-
tery last. If you are conducting the link test with several devices started in various time frames, it is
possible that the devices that start and complete the link test first can transition to RF Scan test,
when the devices that began later are still in the link test mode. The RF Scan test may take up to 70
minutes and you have to check the LED patterns for results. The LED patterns are given below.
transition to RF Scan test. On devices addressed below 100, the link test results stay until the bat-
tery last. If you are conducting the link test with several devices started in various time frames, it is
possible that the devices that start and complete the link test first can transition to RF Scan test,
when the devices that began later are still in the link test mode. The RF Scan test may take up to 70
minutes and you have to check the LED patterns for results. The LED patterns are given below.
Results of RF Scan Test
Table A.2 RF Scan Test Results - LED Pattern
Retrieving Site Survey Results
To retrieve the site survey results, do the following:
1.
Reboot the devices by removing and inserting the battery back in to the device.
2.
Plug in the USB adapter in to the laptop/PC where you have installed the PC tool.
3.
Bring the devices within a range of 20ft from the USB adapter.
4.
Launch PC tools application and retrieve the data.
State
Pattern
LED
Result
In Progress- 70 minutes
remaining
remaining
7 short blinks (Solid) every 30
seconds
seconds
Red
Bad
In Progress- 70 minutes
remaining
remaining
7 short blinks (Solid) every 30
seconds
seconds
Yellow
Marginal
In progress- 70 minutes
remaining
remaining
7 short blinks (Solid) every 30
second
second
Green
Good