Wilson Electronics LLC 2B1216 Manuale Utente
3
4
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com Mon.- Fri. Hours: 7 am to 6 pm MST.
Warning: Use only a Wilson Electronics power
supply . Use of a non-Wilson Electronics product
could damage your equipment . It is very
important to power your Signal Booster using a
surge protected AC Power Strip with at least a
1000 Joule rating.
!
Warning: Verify that both the Outside
Antenna and the adapter extension cable
are connected to the Signal Booster before
powering up the Signal Booster .
!
Testing a Wilson Electronics Signal Booster
To test your Signal Booster, go to a weak signal area where your cell phone registers only
1-2 bars without the Signal Booster turned on . Then, connect the Signal Booster to the
phone and you should see a signal improvement of 2 or more bars .
Note: Many phones take up to 30 seconds to reset the bar indicator.
In-Building Installation
This is the recommended install for in-building use .
Contact our Technical Support Team for more information at:
866-294-1660 or tech@wilsonelectronics .com
Lightning
Surge Protector
(sold separately)
GSM High Power
Powerstrip Surge
Protector
Wide Band
Directional Antenna
Point toward cell tower
Power Supply
Connect to cell
phone or data
card
To Outside Antenna
Carefully insert the power cable .