Wilson Electronics LLC 460013 Manuale Utente

 1 .   Install the antenna to a window . These 

instructions are for use with the Wilson 

Electronics Magnet-Mount or Mini-Magnet 

Mount Antenna . If you purchased a different 

antenna separately, follow the instructions 

included with that antenna . 

 

•   Select a window on the side of the building 

where you get the strongest cell signal . You 

can determine the strongest signal area by 

walking around the building and checking 

the bars on your mobile phone . You should 

wait 30 seconds for new signal strength 

to register . For a more accurate method 

of determining signal strength, read the 

instructions at http://www .wilsonelectronics .

com/test-mode-instructions . 

 

 

•   Clean a spot as high on the designated 

window as possible with the alcohol prep pad . 

 

Attach the suction cup bracket to the cleaned spot 

on the inside of the window . 

 

 

NOTE: Many newer energy efficient windows use 

a metal coating that may decrease the strength 

of a cellular signal, reducing the effectiveness of 

the MobilePro . If you have dual pane windows, 

consider a Wilson Electronics signal boost product 

that provides an option for mounting an antenna on 

an outside wall or roof of a building . 

 

•   With the bracket in place, attach the 

magnet base of the antenna to the flat 

surface of the bracket . The antenna must 

be mounted vertically for the best signal .

2 .   Attach the antenna to the MobilePro 

signal booster . Connect the cable from the 

antenna to the connector on the bottom 

of the signal booster . Do NOT plug in the 

power supply (step 4) until the antenna 

cable is connected to the MobilePro signal 

booster .

3 .   Place the MobilePro signal booster in a 

convenient location close to your cellular 

device . This can be on a desk, a tabletop, 

a shelf, or the optional desktop mount (sold 

separately) . The MobilePro works best when 

within three feet of your mobile device .

 

4 .   Connect the MobilePro to a power supply . 

Attach the AC power cord to the mini-USB 

port on the bottom of the signal booster . 

Plug the AC power cord into a surge 

protected power strip .