ORCOM Co. Ltd OP-42TN Manuale Utente

10

To view television channels correctly, a signal must be received by the set
from one of the following sources:

• An outdoor aerial
• A cable television network
• A satellite network

In the first three cases,connect the aerial or network input cable to the
75 

Ω

coaxial socket on the rear of the PDP.

If you are using an indoor aerial,you may need to turn it when tuning
your PDP until you obtain a picture that is both sharp and clear.
For further details, refer to:
• “Storing Channels Automatically” on page 13
• “Storing Channels Manually” on page 14

The angle can be adjusted from 0 ° to 15 ° by  ±2 °.

In order to watch television programmes broadcast via a satellite network,
you must connect a satellite receiver to the rear of the PDP. Also, in order to
descramble a coded transmission signal, you must connect a decoder to the
rear of the PDP.

Using a Coaxial cable

Connect a coaxial cable to the:
• Receiver (or Decoder) output socket.
• Television aerial input socket.

NOTE : If you wish to connect both a satellite receiver (or decoder) and

a VCR,you should connect the: 

• Receiver ((or Decoder)to the VCR 
• VCR to the PDP
Otherwise,connect the receiver (or decoder)directly to the PDP.

ANT

Cable Television

Network

AUDIO

L

R

ANT

OP-42TN1U/42TN2U(GB)   2004.10.1 10:37 AM  ˘

` 10   mac001  1200DPI 100LPI