Netgear 07300069 Manuale Utente

4-1

This chapter provides information about troubleshooting your RangeMax WN111 Wireless-N 
USB 2.0 Adapter. For information about connecting to wireless networks and the Internet, see 

Use the information below to solve common problems you may encounter. Also, refer to the 
knowledge base on the NETGEAR website at 

.

The LED is not lit

The WN111 is not connected to the USB port properly or the 
WN111 software is not loaded. 
• Remove and reinsert the WN111.
• Check the Windows device manager to see if the WN111 is 

recognized and enabled. Reload the WN111 software, if 
necessary.

• Try to install the WN111 in a different USB slot on your 

system if one is available.

The LED blinks but the WN111 is not 
connected to an access point.

The WN111 is trying to connect to an access point, but cannot 
connect. 
• The access point may not be powered on. 
• Or, the access point and the WN111 are not configured with 

the same wireless parameters. Check the SSID and WEP 
settings.

I cannot connect to an access point. 
The access point is available and there is 
good signal strength.

• If the access point is WPA-PSK protected, you need the 

correct WPA-PSK passphrase. Otherwise, the WN111 will 
still be connected to the previous access point and you will 
not be able to change to the WPA-PSK access point.

• If the access point is WEP protected (either 64 or 128 bit 

encryption), you will be prompted to enter the WEP 
encryption security information.