Denso Wave BHT710BB Manuale Utente
16
Prep
ar
at
ion
Charging Precautions
● Do not touch the BHT, battery, or charger terminals by hand or stain them. Doing so
could result in a contact failure or prevent charging.
● Never charge the battery near fire or in a high-temperature environment.
High-temperatures may activate the charger
’s protective device, preventing charging,
and lead to protective device damage, overheating, blowout or combustion.
● Terminate charging if not completed even after the specified time has elapsed.
Preparation
Follow the steps below to prepare the BHT for use.
Step 1 Charging (Page 16)
First charge the battery.
Step 2 Attaching the Stylus (Page 21)
Attach the stylus to
prevent it from being
lost.
prevent it from being
lost.
Step 3 Turning ON the Power (Page 22)
Preparation
is
now
complete.
Step 1 Charging
The BHT battery is not charged when purchased and must therefore be charged prior
to use.
The following chargers can be used with the BHT.
to use.
The following chargers can be used with the BHT.
Communication units: CU-733, CU-714
Battery chargers:
CH-751, CH-704
*
The CH-704 charger is used for charging individual batteries, and the CH-751 is a
stand-type (same type as CU (communication unit) charger.)
stand-type (same type as CU (communication unit) charger.)
The charge time is approximately 3 hours (standard rechargeable
battery cartridge) or 6 hours (large-capacity rechargeable battery
cartridge).
battery cartridge) or 6 hours (large-capacity rechargeable battery
cartridge).
An almost completely discharged battery cartridge should take this time to become
fully charged.