Maxon Electronics Australia Pty. Ltd. MM-5100 Manuale Utente
MM-5100 Hardware – User Manual
Jan. 22, 2003
2 of 18
FCC RF EXPOSURE COMPLIANCE
In August 1996 the Federal Communications Commission (FCC) of the United States with its action
in Report and Order FCC 96-326 adopted an updated safety standard for human exposure to radio
frequency (RF) electromagnetic energy emitted by FCC regulated transmitters. Those guidelines
are consistent with the safety standard previously set by both U.S. and international standards
bodies. The design of this phone complies with the FCC guidelines and these international
standards.
Use only the supplied or an approved antenna. Unauthorized antennas, modifications, or
attachments could impair call quality, damage the phone, or result in violation of FCC regulations.
The use of this device in any other type of host configuration may not comply with FCC RF
exposure requirements and should be avoided. During operation, a 20cm separation
distance should be maintained between the antenna, whether extended or retracted, and the
user’s/bystander’s body (excluding hands, wrists, feet, and ankles) to ensure FCC RF
exposure compliance.
CAUTION
Change or modification without the express consent of Maxon Electronics Australia Pty. Ltd. voids
the user’s authority to use the equipment. This equipment has been tested and found to comply
with the limits pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in an appropriate installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not used in accordance with
instructions, can cause harmful radiation to radio communication. However, there is no guarantee
that interference will not occur in a particular installation. If the equipment does cause harmful
interference in radio and television reception, which can be determined by turning the equipment
on and off, the user is encouraged to try to correct the interference by one or more of the following
measures:
Re-orient or relocate the receiving antenna
Increase the separation distance between the equipment and the receiver
Contact Maxon Electronics Australia Pty Ltd. Technical Support for assistance.