Maxon Electronics Australia Pty. Ltd. MM-5100P Manuale Utente

FCC Documentation- CM-5100P CDMA 1X Network card

2/25

Maxon Proprietary : Restricted Distribution

This document is the sole and exclusive property of Maxon

Australia. Not to be distributed or divulged without prior written agreement.

Maxon Electronics Australia Pty. Ltd. 36A Gibson Avenue, Padstow, N.S.W. Australia
Tel : +61 2 9707-2000 Facsimile : +61 2 9707-3328 URL : http//www.maxon.com.au

FCC RF EXPOSURE COMPLIANCE

In August 1996 the Federal Communications Commission (FCC) of the United States with its action in Report

and Order FCC 96-326 adopted an updated safety standard for human exposure to radio frequency (RF)

electromagnetic energy emitted by FCC regulated transmitters. Those guidelines are consistent with the

safety standard previously set by both U.S. and international standards bodies. The design of this phone

complies with the FCC guidelines and these international standards.

Use only the supplied or an approved antenna. Unauthorized antennas, modifications, or attachments could

impair call quality, damage the phone, or result in violation of FCC regulations.

This CDMA PCMCIA Card has been tested for FCC RF exposure hand and body SAR compliance with

the MM-5100P PCMCIA Card form factor. In order to comply with FCC RF exposure requirements, the

CDMA PCMCIA Card module must be operated with the MM-5100P PCMCIA Card form factor. The use

of this device in any other type of host configuration may not comply with FCC RF exposure

requirements and should be avoided. During operation, a 1.5cm separation distance should be

maintained between the antenna, whether extended or retracted, and the user’s/bystander’s body

(excluding hands, wrists, feet, and ankles) to ensure FCC RF exposure compliance.

CAUTION

Change or modification without the express consent of Maxon Electronics Australia Pty. Ltd. voids the user’s

authority to use the equipment. This equipment has been tested and found to comply with the limits pursuant

to Part 15.105 of the FCC rules. These limits are designed to provide reasonable protection against harmful

interference in an appropriate installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not used in accordance with instructions, can cause harmful radiation to radio communication.

However, there is no guarantee that interference will not occur in a particular installation. If the equipment

does cause harmful interference in radio and television reception, which can be determined by turning the

equipment on and off, the user is encouraged to try to correct the interference by one or more of the following

measures:

Reorient or relocate the receiving antenna

Increase the separation distance between the equipment and the receiver

Contact Maxon Electronics Australia Pty. Ltd. Technical Support for assistance.