CipherLab Co. Ltd. 3666BASE Manuale Utente

 

3

 

When you receive your 1166/1266, the battery is separated from 1166/1266. Please 
insert the battery into the bottom of the scanner and lock the battery by pushing the 
clip to power on the scanner. The scanner will beep and the LED will be on when 
power on.   

                                

  

 

Please ensure to remove the battery to power off the scanner if it will not be used 
for a prolonged period. The LED will be off and the power to the scanner will be 
disconnected. 

 

 

Upon powering up the scanner will try to establish an RF connection with its base. 
At this stage we need to “pair” the scanner and base. 

Turn the base upside down and you will find 2 labels.  

The first label has the words “SET CONNECTION” and a barcode. The second 
label is the serial number. 

To link the scanner to the base, scan the “SET CONNECTION” barcode label, the 
scanner will beep once then scan the SERIAL number barcode. The scanner will 
beep twice, low then high beep. When it establishes RF connection with the base 
the scanner will then emit three short ascending beeps. Your “pairing” is 
established. 

 

 

 

 

 

4

 

 

There are three methods to charge the battery. One is placing the scanner on the 
base and another is inserting the battery in front of the base, and the other is 
inserting the power supply into the DC Jack at bottom of the scanner. 

 

Place the scanner with a battery inserted on the base to charge your scanner. When 
charging, the scanner LED will flash RED. When the battery is fully charged, 
around 4 hours from completely empty battery, the LED stays on solid RED.  

      

                      

 

 

Insert the battery in front of the base to charge your battery with the power adaptor 
connected. When charging, the base charging LED will be RED. When the battery 
is fully charged, around 4 hours from completely empty battery, the LED will be 
solid GREEN.