Truth Hardware 4353 Manuale Utente
Danger: To help prevent severe personal injury or death:
o
Read and understand instructions completely before beginning
installation.
installation.
o
When connecting the Sentry 2 system to accessories, read the
installation instructions supplied with each accessory before
beginning installation.
installation instructions supplied with each accessory before
beginning installation.
o
Save ALL instructions.
o
Installer – please be sure to give ALL instructions to the
homeowner once installation is complete.
homeowner once installation is complete.
o
Wiring must be installed by a qualified electrician according to local
and National Electrical Codes (N.E.C.)
and National Electrical Codes (N.E.C.)
o
Disconnect main power before beginning installation! Verify that
power is OFF at the main breaker or fuse panel by testing with a
voltage meter that you know is working correctly.
power is OFF at the main breaker or fuse panel by testing with a
voltage meter that you know is working correctly.
o
Connect power only after motor connections and settings are
verified.
verified.
o
This equipment does not provide a method to shut off power, and
should be connected to a dedicated breaker or fused power circuit.
should be connected to a dedicated breaker or fused power circuit.
o
The Sentry 2 system should not be used on windows that are
intended to meet egress codes.
intended to meet egress codes.
o
The Sentry 2 system is intended for indoor use only, with screens in
place.
place.
o
The screen interlock MUST be correctly mounted and is a required
part of the installation. It is intended to help prevent injury that could
result from reaching into the window or skylight area during
operation. The correct installation of the screen interlock is the
responsibility of the installer.
part of the installation. It is intended to help prevent injury that could
result from reaching into the window or skylight area during
operation. The correct installation of the screen interlock is the
responsibility of the installer.
o
Do not allow children to operate the wall push buttons or remote
control transmitter(s).
control transmitter(s).
LANGUAGES
ENGLISH PAGE 1
ESPAÑOL PAGINA 10
FRANÇAIS PAGE 20
ENGLISH PAGE 1
ESPAÑOL PAGINA 10
FRANÇAIS PAGE 20
Made in USA
An FKI Industries Company
700 West Bridge Street
Owatonna, MN 55060
1-800-324-4487
www.truth.com
Form 90059 R1
Hand Held Remote
Operating Instructions
Sentry II
®