ViVOtech Inc. VP4800M Manuale Utente

ViVOpay 4800 User Guide

 8               

Installing the ViVOpay 4800

6. If you are planning on using either of the two channels on the bottom of the stand, make 

sure to route the RJ45 10-pin cable (and optionally, the power cable) through the stand.

7. Attach the power cable and the RJ45 10-pin connector into the base of the ViVOpay 

4800. Make sure that the cables are routed into the channels.

8. Reattach the stand if it was removed for routing the cables. Note that the stand helps to 

hold the cables in the channels.

9. Attach the other end of the RJ45 10-pin cable to the POS/ECR and plug the power 

module into an electrical outlet. The reader will beep twice and be ready for operation 
after approximately 35 seconds.