Chung Nam Electronics Co. Ltd. WLC311NR Manuale Utente
OEM installation Manual
- 10 -
Chapter 3
: Connect to Wireless Access Point
This section shows you how to configure the WLC311NR WLAN module in order to
getting connection to a wireless access point. There are two kinds of ways that you
can carry out this task:
getting connection to a wireless access point. There are two kinds of ways that you
can carry out this task:
•
Using
Ralink Configuration Utility to connect the wireless access point.
•
Using Windows built-in
Windows Zero Configuration Utility to connect
the wireless access point.
3.1 Using Ralink Configuration Utility
Below instructions show you how connect to the wireless access point using Ralink
Configuration Utility:
1. Right-click the Ralink configuration utility icon located at low-right corner of
your embedded system, click
Launch Config Utilities, Figure 2-7 will appear.
2.
To add a new connection profile, you can either
•
Create a new profile or
•
Modify a profile from an existing wireless access point or wireless device.
Figure3-1 Profile setting