ZTE Corporation A410 Manuale Utente

Additional safety information

 

61

more of the following measures: 
*-  Reorient or relocate the receiving  

antenna. Increase the separation  
between the equipment and 
receiver. 

*-  Connect the equipment into an  

outlet of a circuit different from that 
to which the receiver is connected. 

*-  Consult the dealer or an  

experienced radio/TV technician 
for assistance. 

Changes or modification not  
expressly approved by the party  
responsible for Compliance could 
void the user’s authority to operate  
the equipment. Connecting of  
peripherals requires the use of 
grounded shielded signal cables.
 FCC hearing-aid compatibility  
(HAC) regulations for wireless  
devices
On July 10, 2003, the U.S. Federal 
Communications Commission (FCC) 
Report and Order in WT Docket  
01-309 modified the exception of 

wireless phones under the Hearing 
Aid Compatibility Act of 1988 (HAC 
Act) to require digital wireless phones 
be compatible with hearing-aids. The 
intent of the HAC Act is to ensure 
reasonable access to  
telecommunications services for  
persons with hearing disabilities. 
While some wireless phones are 
used near some hearing devices 
(hearing aids and cochlear implants),  
users may detect a buzzing,  
humming, or whining noise. Some 
hearing devices are more immune 
than others to this interference noise, 
and phones also vary in the amount 
of interference they generate. The 
wireless telephone industry has  
developed a rating system for  
wireless phones, to assist hearing 
device users find phones that may 
be compatible with their hearing 
devices. Not all phones have been 
rated. Phones that are rated have the 
rating on their box or a label located 
on the box. The ratings are not  
guarantees. Results will vary  

only belt-clips, holsters or similar  
accessories that maintain 2.0 cm 
separation distance between the 
user’s body and the back of the 
phone, including the antenna. The 
use of belt-clips, holsters and similar  
accessories should not contain  
metallic components in its assembly. 
The use of accessories that do not 
satisfy these requirements may not  
comply with FCC RF exposure  
requirements, and should be avoided.  
For more information about RF  
exposure, please visit the FCC  
website at www.fcc.gov.
FCC compliance information
This device complies with Part 15 of 
FCC Rules. Operation is subject to 
the following two conditions:
(1)  This device may not cause harmful 

interference, and 

(2)  This device must accept any  

interference received. 

Including interference that may cause 
undesired operation.

U.S.A.  
U.S.FEDERAL COMMUNICATIONS 
COMMISSION RADIO FREQUENCY 
INTERFERENCE STATEMENT
INFORMATION TO THE USER

 

This equipment has been tested 

and found to comply with the limits 
for a Class B digital device pursuant 
to Part 15 of the FCC Rules. These 
limits are designed to provide  
reasonable protection against  
harmful Interference in a residential  
installation. This equipment  
generates, uses, and can radiate 
radio frequency energy and, if Not 
installed and used in accordance with 
the instructions, may cause harmful 
Interference to radio communications. 
However, there is no guarantee 
that interference will not occur in a 
particular Installation.  
If this equipment does cause harmful  
interference to radio or television  
reception, which can be determined 
by turning the equipment off and on, 
the user is encouraged to try to  
correct the interference by one or 

60

 

Additional safety information