ZTE Corporation A611PLUS Manuale Utente

9 

 Mute 

 Vibration 

 

New message; no space for messages when blinking 

 

Battery charge level

 

Technical Parameters 

Type   

 

     

 

ZTE A611+ 

Dimensions（L×W×H）  

93 mm×47.8 mm×15.9 mm 

Weight  

 

  

     Approx. 80 g (with battery) 

Continuous standby time   

Approx. 120 hours - 150 hours (subject to network status) 

Continuous talk time   

     

Approx. 2 hours – 3 hours (subject to network status) 

For other parameters about battery and charger, refer to their labels.   

Battery 

The accessory

lithium battery of the handset can be immediately used after unpacking. A new battery will have 

the best performance after full charge/discharge cycles for the first three times. 

„ 

Remove: Switch off your phone, slide down the cover and then lift the battery from the compartment to remove it. 

„ 

Install: Insert the battery by aligning the metal contacts on the battery with the metal contacts in the battery 

compartment on the phone. Push down the battery until it clicks into place and then install the battery cover. 

„ 

Plug the charger connector into the charge port on the left side of the phone. (Note: Put upward the side with 

arrow.) Then plug the other end of the charger in an appropriate electrical outlet. 

„ 

Now, a charge indicator displays in the upper right corner of the screen. If the battery is charged in power-off 

condition, the indicator bar will scroll. If the phone is over-used in shortage of battery or not used for a long time, 

it will take a few minutes for the indicator bar to show.   

„ 

When the battery is fully charged, the bar stops scrolling. Generally the whole charge process needs two to 

three hours (charge the battery for six to eight hours for the first three times). Normally, during the charge 

process, your phone, battery and charger may become hot.   

„ 

Disconnect the charger with the phone and the power outlet when charge finished. 

„ 

Put the phone at a ventilated place with temperature between + 5℃ - + 40

. 

℃ Use only the supplied or approved 

chargers. Using unauthorized charger may cause danger and violate the authorization and warranty rules of the 

phone. 

„ 

Charge the battery in time when your phone automatically powers off or displays a warning “Battery low”.   

„ 

The conversation time and standby time of the phone lie on ideal working environments. In practice, the battery 

working time varies with different network conditions, working environments and modes. 

Connecting to the Network 

Do not touch the metal contact area of the SIM card (Subscriber Identity Module card). Doing so may cause 

information in the card lost or destroyed. Keep the card away from electricity and magnetism.