ZTE Corporation AC8700 Manuale Utente
CDMA2000 1X EV-DO Wireless Data Terminal User Guide
ZTE Corporation
http
//wwwztecomcn
Common Failures Table:
Failures
Causes
Solutions
Error occurs when running
setup.exe file.
The setup file may be damaged.
Please download the program on
our website
WWW.ZTEIT.COM
and reinstall it.
Directly run the software before the
Data Terminal is plugged in.
Close the software, plug in the Data
Terminal and run it again.
Open port failed.
The port is occupied by other
applications, such as “Hyper terminal”,
or the software is already run.
Close relevant software and run the
software again.
R-UIM card is not inserted.
Insert R-UIM card.
R-UIM card isn
ÿt inserted properly.
Sometimes the front side and back side
are confused.
Please refer to section 4.2. Properly
insert R-UIM card.
No R-UIM card.
R-UIM card is damaged. Validate by
using a CDMA terminal.
Replace R-UIM card.
Antenna is not connected to the Access
Box.
Insert the antenna into the Data
Terminal.
Out
of
the
network
service
area.
Make sure it is in the CDMA
network service area.
No signal indicated.
The antenna or RF component is
damaged.
Replace relevant damaged parts.
Wrong setting of parameters (Phone,
User, Password)
Correct the parameter settings.
Consult your service provider for
details.
Not enough money in R-UIM card.
Consult your service provider for
details.
Dialing failed
Network congestion or failure.
Try again later.
The Data Terminal is being connected.
(It usually occurs when the Internet
connection is immediately made after
the call is dialed)
Reconnect.
Internet connection failure.
Poor network signal.
View signal strength indication and
check if the antenna is properly
inserted.