ZTE Corporation MF25A Manuale Utente
22 Confidential and Proprietary Information of ZTE CORPORATION
1.Set the same SSID and channel for APs
Manually set the SSID and channel is strongly
recommended.
recommended.
2.Select WDS mode: Disable, Lazy Mode, Bridge Mode or
Repeater Mode
Repeater Mode
·If you select Disable, WDS is disabled.
·If you select Lazy Mode, WDS is enabled, and set
wireless MAC address only on the peer APs.
wireless MAC address only on the peer APs.
·If you select Bridge Mode, WDS is enabled, and set the
peer APs wireless MAC address on router. When you set
Bridge Mode, your PC can not search SSID of AP after
connected.
peer APs wireless MAC address on router. When you set
Bridge Mode, your PC can not search SSID of AP after
connected.
·If you select Repeater Mode, WDS is enabled, and set
the peer APs wireless MAC address on router. When you
set Repeater Mode, your PC can search SSID of AP after
connected.
the peer APs wireless MAC address on router. When you
set Repeater Mode, your PC can search SSID of AP after
connected.
3.Select Phy mode:
CCK,OFDM, HTMIX or GREENFIELD
CCK: 802.11b
OFDM: 802.11g
HTMIX: 802.11b/g/n Mixed Mode
GREENFIELD: 802.11b/g/n Mixed Mode
4.Select Encrypt Type:
WEP, TKIP, AES
If you select NONE, all the data transmitted without
encryption, and other station can access router.
encryption, and other station can access router.
5.Set peer AP's wireless MAC address on router
Only Repeater Mode and Bridge Mode need this.
The HT physical Mode parameters are shown below:
•
Operating Mode: In Mixed Mode, packets are transmitted with a preamble compatible with the legacy
802.11a/g, the rest of the packet has a new format. In Green Field, high throughput packets are
transmitted without a legacy compatible part.
transmitted without a legacy compatible part.
•
Channel Bandwidth: Set the HT physical channel bandwidth.
•
Guard Interval: Guard interval is to introduce immunity to propagation delays, echoes and reflections,
to which digital data is normally very sensitive.
•
MCS: The Modulation and Coding Scheme (MCS) is a value that determines the modulation, coding and
number of spatial channels.
•
Reverse Direction Grant(RDG): Enable RDG or not.
•
Extension Channel: Set extension channel. Extension channel is also able to send and receive data.
•
Aggregation MSDU(A-MSDU) :To enable Hyper Throughput TX Aggregate MAC Service Data Unit,
select Enable.
•
Auto Block ACK: Select to block ACK (Acknowledge Number) or not during data transferring.
•
Decline BA Request: Select to reject peer BA-Request or not.
Click Apply to confirm your configuration.
Advanced
Select Wi-Fi Setting > Advanced
•
Beacon Interval: The router broadcasts beacon message to announce that it has buffered frames to
deliver. The default value is 100 (ms).Beacons are packets sent by an access point to synchronize a
wireless network. Specify a beacon interval value. is recommended.
wireless network. Specify a beacon interval value. is recommended.
•
Data Beacon Rate(DTIM): A Delivery Traffic Indication Message(DTIM) informs next clients to listen
to broadcast and multicast messages.
•
Fragment Threshold: This value should remain at its default value of 2346. If you experience a high
packet error rate, you may slightly increase your fragment threshold. Setting the fragment threshold too