ZTE Corporation ZTEA711 Manuale Utente

 

9

when it is connected to an outer power source. 

       

 

„ 

Switch off your phone, disconnect the outer power source and remove the battery. 

„ 

Insert the SIM card into the SIM card slot or pull it out from the slot. 

Hold the End key to power on/off the phone. 

The mobile phone will automatically test whether the SIM card is plugged in and valid after power on, then the 

following messages will be displayed on the screen sequentially.： 

Enter PIN 1——if a SIM card password has been set.   

Enter lock code——if the handset is locked, you need to enter the lock code to unlock it..   

Searching  ——search for the right network. 

By setting a PIN 1 (personal identification number) code of the SIM card and the handset lock code, you can 

protect your SIM card and phone from illegal use.   

„ 

Method to unlock the SIM card: Enter a PIN 1 code and press the # key or Left soft key [OK]. 

If you enter an incorrect PIN 1 code three times in a row, your SIM card will be locked by the network and the 

phone will ask for PUK code instead. 

Note: Your service provider will set a standard PIN 1 code (four to eight digits) for your SIM card; please change 

it with your private password as soon as possible.   

„ 

Method to unlock the phone: Enter the handset lock code and press the # key or Left soft key [OK]. 

Note: If you forget your handset lock code, please connect with your distributor or the authorized local customer 

service center. 

After the SIM card and the phone are unlocked, the mobile phone will automatically search for the network. 

After a few seconds, your phone will be registered on the network. Now your phone is in the standby mode. 

Besides receiving and sending calls, you can do the following things: 

„ Press 

the 

Right soft key to enter the Messaging interface. 

„ Press 

the 

Left soft key or OK key to enter the function menu. 

Note: If “Emergency only” is shown on your screen, you can only send emergency calls.

 

Basic Operations 

Making a Call 

You can make or answer calls in the standby mode. The information bar in the upper left corner of the screen 

shows the network signal strength. 

 

„ 

Making DDD (Domestic Direct Dialing): Input the telephone number by Number keys (including the area code 

when making a long distance call), press the Dial key to send a call. Press the End key to end a call. 

„ 

Dialing an extension number: