ZTE Corporation ZXG-BTS2 Manuale Utente

Chapter 5 - Networking Modes and System Configurations

Confidential and Proprietary Information of ZTE CORPORATION 97

A B L E

U M B E R O F

O N F I G U R E D

A R R I E R S F O R A L L

8 0 W T R X

S A N D T H E

O R R E S P O N D I N G

E L A T I O N S H I P

E T W E E N

C D U

S A N D

N T E N N A E

O N F I G U R E D I N

N E

E L L

TRX
QTY.

Antenna QTY.
and
Configuration

CDU
QTY.

RDU
QTY.

CEU
QTY.

Remarks

1 2,TX/RX,RX 1 1

- Special treatment for CDU.

See Appendix C

2 2,TX/RX,TX/RX 2 -

- Special treatment for CDU.

See Appendix C

3~4 2,TX/RX,TX/RX 2

5~6 2,TX/RX,TX/RX 2

For different configuration requirements of different site types, the

combinations listed above can be used.

Expansion Configuration

To increase the cell subscribers, one to three racks can be configured in

one cell generally. In principle, a cell should be configured with as fewer
racks as possible. For 40 W PA configuration, ZXG10-BTS (V2.9) can be

configured as a S12/12/12-type site at maximum; and for 80 W PA
configuration, ZXG10-BTS (V2.9) can be configured as a S6/6/6-type site

at maximum.

Configuration Example

The ZXG10-BTS (V2.9) has multiple configuration modes with different
combinations, and all configurations are based on the user requirements

and network planning. Therefore, system configuration modes vary with
different application sites. A site is typically configured as an omni-
directional site, 2-sector site or 3-sector site.

Configuration Examples of O-type Site

Introduction to the configuration of O1/O2/O4/O6/O8 type sites is given as

follows.

Figure 82 illustrates the configuration of the O1-type site.

For the O1-type site, the configuration with one CDU, one RDU, one omni-
directional transceiving antenna and one omni-directional receiving

antenna is generally employed.

The logical connection relationship between the combiner units and

distribution units is shown in Figure 83.