ZTE Corporation ZXG-BTS2 Manuale Utente

Pagina di 139
 
ZXG10-BTS (V2.9) Technical Manual 
Confidential and Proprietary Information of ZTE CORPORATION  
GPRS/EDGE: GPRS/EDGE packet data service 
 
It supports the GSM900, EGSM900, GSM850, GSM1800 and GSM1900 
systems. Modules of different bands can be inserted in the same 
cabinet.  It also supports EDGE carrier module ETRM and common 
carrier module TRM to be inserted in the same cabinet. 
 
It supports CS1 ~ CS4 encoding modes of GPRS and MCS1 ~ MCS9 
channel encoding modes of EGPRS, and it can adjust the channel 
encoding mode dynamically according to the monitoring and 
measurement results.  
 
It supports space diversity, frequency diversity, time diversity, 
polarization diversity, and maximum ratio combination diversity 
technologies.  
 
The receiving end adopts the Viterbi soft decision algorithm, improving 
the channel decoding performance and increasing the system receiving 
sensitivity and anti-interference capability. 
 
It supports frequency hopping, improving the system capability against 
Rayleigh fading. 
 
It supports DTX, decreasing transmitter power, lowering total 
interference level of air signals. 
 
It supports calculation of timing advance TA. 
 
It supports cells covered with a maximum 120 kilometers in radius. 
 
It calculates the time advance amount. 
 
It supports two types of power output, 40W and 80W, in the bands 
GSM900 and EGSM900. It supports 40 W output in the GSM1800, 
GSM1900 and GSM850 bands.  
 
A single cabinet (40 W) supports 12 TRXs, and can be expanded to 36 
TRXs at the same site. One site supports S12/12/12 expansion. 
 
A single (80 W) supports 6 TRXs, and can be expanded to 18 TRXs at 
the same site. One site supports S6/6/6 expansion. 
 
Star, chain and tree networking modes of the Abis interface are 
supported. 
 
The Abis interface implements E1 transmission through satellite link. 
Unidirectional transmission delay of the Abis interface is 260 ms.  
 
The Abis interface supports 1: 4 TEI multiplexing of LapD signaling. 
That is, it can multiplex four pieces of LapD signaling to one 64 Kbit/s 
signaling timeslot through TEI 
 
When multiple BTSs are cascaded, the automatic crossover protection 
function is provided for the Abis interface link when any BTS is 
powered off. 
 
It supports preprocessing of the measurement reports of the BTS. 
 
It supports base station power control: static, level-6; dynamical, 
level-15. 
 
It supports all paging modes specified in GSM.   
 
It supports synchronous handover, asynchronous handover, pseudo-
synchronous handover, and pre-synchronous handover.