ZTE Corporation ZXV10P802 Manuale Utente
45
NOTE: Dialtone and dialed number display occurs after the phone is
off-hook and the line key is selected. The phone waits 4 seconds (by
default; No key Entry Timeout) before sending and initiating the call.
Press the “SEND” or “#” button to override the 4 second delay.
Making Calls using IP Addresses
Direct IP calling allows two phones to talk to each other in an ad-hoc fashion
without a SIP proxy. VoIP calls can be made between two phones if:
without a SIP proxy. VoIP calls can be made between two phones if:
z
Both phones have public IP addresses, or
z
Both phones are on a same LAN/VPN using private or public IP
addresses, or
addresses, or
z
Both phones can be connected through a router using public or private
IP addresses (with necessary port forwarding or DMZ)
IP addresses (with necessary port forwarding or DMZ)
To make a direct IP call, please follow these steps:
1. Press MENU button to bring up MAIN MENU
2. Select “Direct IP Call” using the arrow-keys
3. Press OK to select
4. Input the 12-digit target IP address. (Please see example
below)
5. Press OK key to initiate call
To make a quick IP call, please refer to next section.
For example: If the target IP address is 192.168.1.60 and the port is 5062 (e.g.
192.168.1.60:5062), input the following: 192*168*1*60#5062 - The “ * ” key
represent the dot“.” ; The “#” key represent colon “:”. Press OK to dial out.
192.168.1.60:5062), input the following: 192*168*1*60#5062 - The “ * ” key
represent the dot“.” ; The “#” key represent colon “:”. Press OK to dial out.
Quick IP Call Mode
The ZXV10 P802 also supports Quick IP call mode. This enables the phone to
make direct IP-calls, using only the last few digits (last octet) of the target
phone’s IP-number.
make direct IP-calls, using only the last few digits (last octet) of the target
phone’s IP-number.