Bowens 5150 Manuale Utente

Congratulations on choosing the Bowens Pulsar Radio Trigger.

Designed using the latest technology to produce a unit that is simple to
operate, Pulsar is capable of triggering the widest range of photographic
equipment including studio flash, cameras and light meters.

Pulsar can be used as either a Transmitter or Receiver allowing the ability
to quickly change your lighting settings. You can easily substitute one
Pulsar with another by simply changing its mode or Channel settings.
This is just one example of the versatility of Pulsar. In order to fully
understand the many studio uses for your new Pulsar  Radio Trigger,
please take a moment to read through this user guide.

Included in box:

1  x  Instruction Manual
1  x  Pulsar
2  x  AAA Batteries
1  x  Fixing Bracket
1  x  Elastic Cord with Ends
4  x  Rubber Feet
1  x  Sync Cord
1  x  Jack Plug Adapter

Try this first:
Check the indicator on each unit is 'single flashing' indicating that the unit
is ON and the battery is OK.
Set both transmitter and receiver to studio ‘A’ and channel ‘All’
Turn all units OFF then back ON.

Note:
Units may not operate correctly if used in very close proximity to each other.

Indicator on unit does not light when test button pressed.
Try replacing batteries.
Make sure power switch is set to either Transmit or Receive.
Remove external power connector, to use internal batteries.

Unit does not receive code.
Set both transmitter and receiver channel select to All.
Try using units in another area away from metal objects.

Unit does not trigger device.
Try the test button on the receiver to confirm electrical connection.
Check cable connections.
Try the alternative Sync output of the Pulsar.

Unit is continually transmitting.
Make sure test button is not obstructed.
Try disconnecting external trigger sources.
Check Battery condition.
Turn Pulsar OFF then back ON.

In the unlikely event of a problem or fault with your Pulsar please contact
Bowens for additional help or to arrange a repair.