Redline Communications Inc. AN80IB Manuale Utente
User
AN-80i
Manual
70-00072-01-06a
Proprietary Redline Communications © 2008
Page 28 of 96
June 1, 2008
Wireless Configuration
Use settings on the following screen to configure the AN-80i wireless interface.
Figure 10: Web - Wireless Configuration Screen
RF Freq. [MHz]: Enter the center frequency for the RF channel. This setting must be
identical for both AN-80i systems operating as a wireless link. The options key controls
channel availability. Refer to Table 51: Spec. - Regional Identification Codes on page 92
for available channels. Use the Autoscan feature to enable use of multiple channels.
When the Auto Scan field is not checked, the PTP Slave will only register with a PTP
Master operating at the frequency specified in the RF Freq. [MHz] field.
identical for both AN-80i systems operating as a wireless link. The options key controls
channel availability. Refer to Table 51: Spec. - Regional Identification Codes on page 92
for available channels. Use the Autoscan feature to enable use of multiple channels.
When the Auto Scan field is not checked, the PTP Slave will only register with a PTP
Master operating at the frequency specified in the RF Freq. [MHz] field.
Important: To minimize interference, the channel frequencies for AN-80i links
operating in close proximity should be separated by a minimum of the channel size in
use (to avoid overlapping bands).
operating in close proximity should be separated by a minimum of the channel size in
use (to avoid overlapping bands).